If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Right click on com port 1, select properties, now select the Port setting tab, ensure Bits per second is set to maximum then click advance, at the bottom change com port number to 3, press OK OK and try the flash again.
I been struggling for ages with all sorts of serial apps and also the speed of the port, since changing to these settings everything is 100% THANK YOU VERY MUCH
Comment