EX7000 HD-No Channels

[badapple]

It may be that the flash has not taken hold properly.
to eliminate this try clear data/factoty re-set and re- flash the unit again. It will not do any harm and u never know.
I have had some Euros that I had to flash 3 times before they worked proper.

[New2Eurovox]

Dont have a splitter or anything like that

Just pulled out the cables from the back of the standard box and plugged them into the 7000

Have plugged the Vbox in twice now and its still comming up with all the channels

Checked all the cables and connections and they are all fine aswell

[New2Eurovox]

how do i clear the data so that i can re-flash it?

done the factory reset and put the usb in and turned it off to start again but it jst came up same version on the front of the 7000

[chic.]

it wont download that firmware because it's already got it download the earliest 1 and put that on first then the latest 1

[New2Eurovox]

Just noticed that there is a splitter for the tv cable and the braodband

would this affect the 7000 finding the channels?

[badapple]

Remove the main incoming cable from the splitter and plug it straight in the box. Clear the channel data from the box and re-scan.
U can put the splitter back after the scan(hopefuly it would have picked up the channels)

[chic.]

lazy ****s at vm thay are supposed to run another feed for your pc

[chic.]

have you got it sorted

[ravster]

I can no longer access the configuration menus in my EX7000,
when I press menu, and then select Deepscan, Fast install or even factory reset (any of that menus options), including the fast colour keys for EZ Config/ install I get the "Enter PIN" prompt, and as soon as I enter the 4th digit the following occurs:

- The PIN prompt dissapears as though nothing happened.
- No indication that PIN was right,
- No indication that PIN was wrong,
- nothing at all,
- the existing menu is simply displayed there in the default state as when the MENU button is pressed.

I tried reflashing - which I could only do by going back to an earlier (Jan '09) flash.tbn file because when you switch the box on and off the search for a flash file also checks that the version is the same, so if you try to flash with the same version the display will read "Same Version", and ignore it. So you must go back to an earlier version (which I also tried to access any of the config menus with) without joy, then I reflashed to the later firmware again (Mar '09) with the same failures.

Have tried the codes:

1004
1000
0000
6502 (master reset code)

Any other ideas? Is there a way of doing a factory reset by hardware instead of the menu?