If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
You can force it to boot by pulling out mains ...then holding down the Channel up & Down on the front panel and putting the mains back in until the word Boot appears on display ...release Buttons immediately and box should boot.
if you keep your fingers on buttons for too long then the box will go into Diag ( diagnostic) mode ...if this happens just start again but remember to be quicker at taking your fingers off the up / down buttons
Comment