Hello, had my kryptview working properly for a good few years other than when it goes off or glitches, but never a problem like this
Channels 1 - 5 are not even working, scrambled etc etc
I have updated it. reset it to its factory settings, scanned, and when you reset it to its factory settings and scan again, you have to choose your List of network ID, well that keeps coming up as 'already exist' even though ive reset it to factory settings.
It scans for the channels, says signal strength between 60-88
the TP is scanning, but no channels come up as being found, and says Complete Exit.
Ive checked my box everything is in the right place no loose cables nothing
confused, any help would be appreciated
thanks
Channels 1 - 5 are not even working, scrambled etc etc
I have updated it. reset it to its factory settings, scanned, and when you reset it to its factory settings and scan again, you have to choose your List of network ID, well that keeps coming up as 'already exist' even though ive reset it to factory settings.
It scans for the channels, says signal strength between 60-88
the TP is scanning, but no channels come up as being found, and says Complete Exit.
Ive checked my box everything is in the right place no loose cables nothing
confused, any help would be appreciated
thanks
Comment