Kryptview Firmware Loading Guide / Tutorial.

[omear786]

u flash box only then connect everything up and power it all on, then update to new s/w on line with remote.

i did that but i cant to new software on line with remote when the icon dose not connect to the box???

[lagerland]

I have been trying this for about 6 hours over 2 nights, I am experiencing the same problem as listed above "download not requested" I cannot for the life of me work out whats wrong according to the tutorial I am one screen away from completed.

I have a USB converter and a null cable.

Can anyone please offer any advice on what I am doing wrong, as you can probably tell im not too confident around computers.

Thanks in hope of help

KJ

If your getting that message it sounds like your timing is out m8.So you have the right com port? Box is off hit the download button and then switch on the box................

[cactikid]

i did that but i cant to new software on line with remote when the icon dose not connect to the box???

make sure you have a lan cable connected,maybe box modem and router need powering off then on and retry.

[omear786]

make sure you have a lan cable connected,maybe box modem and router need powering off then on and retry.

done that so many times

[cactikid]

what firmware is on box?

[omear786]

02122011 is the one howver iv tried the earlier one before thay aswell

[cactikid]

yes it needs a lan update,try a factory reset first then power off box at rear then on and retry s/w online update,maybe iconn needs powering off on a few times.

http://www.digital-kaos.co.uk/forums/f99/kryptview-a750-firmware-310173/

[omear786]

tried that stil no luck

[cactikid]

have you tried the one in downloads?

[BRASS EAGLE]

that has fixed ma box, cheers ,,is there a channel editor for these boxes

[cactikid]

dont think so only favourites

[jinsta]

My box kept freezing at 99% on dl update via box. First attempt for doing this, just used this guide, sw mentioned in tut and this link located in downloads. Worked a charm and just needed to factory reset, run update again via box (no freeze, just happily dl'd, unzipped and flashed) and boom back with so far no glitching! Thanks OP

[steb87]

can somebody help me please i am completly new to all this and i am trying to setup a Evolution A750 that is brand new, think i need to flash it etc but am new to all this

[cactikid]

it cant be new as thats an old model,recheck your model again
welcome aboard m8.

[seigneur]

hello world , i m nwebie and i would like to know if someone can give me a link for patching sun create receiver