samsung ms28 re-flash

[SAFC_FTM]

O, when the forum went down a while back, some attatchments were lost, this must have been over looked by myself.

The reason its not showing up in jungleflasher is that there is no wway to recognoze the drive. This is why you will need to device intro the drive on each port, it will show up.

With the VIA drivers removed and the drive hooked up by ck3 do the following:

Under Mtk tab Tick VIA ports only.
Now under the drop down menu at io ports. Select the top port.
Now click the intro/device id button, a pop up warning will come up, saying power off then on the drive within 1 second. do as so.
If no drive is found, move onto the next io port and try again.

I will also re-up the other dos guide now if i can find it.

Thanks for that mate, will try it when i get back home.

Only query i have is that i don't have ck3 kit but i do have rev2 connectivity kit that comes with the x360usb kit so i'm assuming this would also be ok.
Also any reason why you recommended using the middle sata port on the PCi card rather than the back one as the back one seems to be the one recomended in all the tut's?

cheers again

[cunny]

I just find the middle 1 easiest to use. Also the kit, as long as you can power cycle the drive (off/on within 1 second) should be fine, the data (sata) must always be in.

[SAFC_FTM]

I just find the middle 1 easiest to use. Also the kit, as long as you can power cycle the drive (off/on within 1 second) should be fine, the data (sata) must always be in.

cunny

thanks for all your help mate got it sorted this afternoon, really is a piece of pi$$ after going through it and not being too aprehensive!!

again thanks for all the help.

just to let anyone else know i did u the nearest port and it worked ok for me.

cheers