pc wont boot

[cunny]

have u cleared the cmos?

[spondulick]

how do i clear cmos

[Bulld0g]

how do i clear cmos

Take the battery out that looks like a watch battery and leave it out for an hour or so . Or see if theres a jumper on the mobo to clear the cmos. It should tell you in the motherboard manual

[spondulick]

thanks mobo will try that tomorrow will get back to you.

[cunny]

how do i clear cmos

If uncertain, look in the manual i posted for you?

[opsmonkey]

did you de-stactic yourself before you touched the inner working of your PC...??

[spondulick]

yes i did every thing seemed ok

[spondulick]

cleared the cmos by removing battery as sugested still same prob.

[spondulick]

Take the battery out that looks like a watch battery and leave it out for an hour or so . Or see if theres a jumper on the mobo to clear the cmos. It should tell you in the motherboard manual sorry bulldog for calling you mobo,dont know how i managed that

[cunny]

so where are we at with the pc, same place?

[spondulick]

yes we are at same place

[cunny]

Do you still have the support cd that come with the motherboard?
Also unflug everything apart from GFX card and RAM, anf if poss try another GFX Card with the original ram in, clear the cmos on the board:
If you want to erase CMOS...
1. Turn off the computer and unplug the power cord.
2. Remove the battery, wait for 30 second.
3. Re-install the battery.
4. Plug the power cord and turn on the computer.

Also check page 17 of the manual, tells you how to do it bu jumper.

Check all fans are correctly fitting, if there is any posts from the bios, enter and turn off chasis intrusion. Also load failsafe defaults.

[spondulick]

did as above cunny. still same ive found motherboard support disk.

[mcgeoff]

If you can get into bios setup. Check this out

FDRAM Clock (MHz)
8Please set DRAM Clock according to your requirement. (Default value: Auto)
If you use DDR266 DRAM module, please set "DRAM Clock(MHz)" to "133-DDR266". If you use
DDR333 DRAM module, please set "DRAM Clock(MHz)" to "166-DDR333". If you use DDR400
DRAM module, please set "DRAM Clock(MHz)" to "200-DDR400".
Incorrect using it may cause damage to your system your system.

[cunny]

see if there is anything in the manual on the disc about the errors, think ur gonna have to start swapping stuff to test the board to see what the problem is