flashing db 500s

[Shady]

pli jade. the one you got...

[Shady]

menu> setup>system settings>factory reset.. then on setup choose no disceqc. then choose 28.2e

[toriandshea]

thanks shady let you know how i get on

[mhalley]

using dream up tried to flash image but all i get is this

2:12:53 PM box type: DM500
2:13:14 PM Ping result: OK, box is alive and speaking to us ;-)
2:13:47 PM Uploading file to box...
2:13:54 PM ERROR , upload aborted!
i didnt erase any thing the image is pli-jade i think its only 5mb any help would be great

Which version of dream up were you using ?
Were you using serial or usb ?

[toriandshea]

serial cable but it worked when i put ethernet cable on aswell

[mark8393]

if its a sky dish that has been up for a few years, i may be pointing at 19.2, so just swing it round a bit

[cgscott]

I reckon you've went to single satellite and the image has pre selected 19.2 and in a hurry you've clicked that so now when you go into transponder scan all that is there is 19.2

Just go into rotor setup and go back to disq selection where you can choose single sat, multi lnb or moto dish settings and choose single satellite but remember to choose 28.2 problem solved.

For the wind to blow a dish from 28.2 to exactly 19.2 is highly unlikely.

[awais1]

Try a different version of dreamup. That is your problem

thanks friend used older version 1.3.3.3 it worked