dm500 PC fan install

[.: JaCkPoT :.]

which two power pins do i use to power a PC fan to help keep my dreambox cool as it des seem to get extremely hot..

[opsmonkey]

have you read this..???

http://www.digital-kaos.co.uk/forums/f39/dm500s-cooling-39693/

also how is it hot..?? have you something on top of the box, blocking the air slots..??

the fan has a blue LED.. right up your street

[.: JaCkPoT :.]

There is nothing on top of the receiver but the case is really hot So i removed the case..cheers for the link..i had seen it before but couldnt find the thread again..cheers

[.: JaCkPoT :.]

all done using a fan from my PC..it had three wires[red/black/white] but i only used the red and black! whats the white one for?

[socktug]

The white one is most likely for the PC's fan sensor. It monitors the speed of the fan and adjusts it as necessary.

[.: JaCkPoT :.]

oh..cheers!

[.: JaCkPoT :.]

this is probably a real dumb question but which way should the fan face? towards the IBM chip or away from it? so like this |> or like |<...the line is the chip..arrow is direction of wind being pushed

[opsmonkey]

this is probably a real dumb question but which way should the fan face? towards the IBM chip or away from it? so like this |> or like |<...the line is the chip..arrow is direction of wind being pushed

.. yes it is..

unless you just want a cold case then make sure the direction of the wind is over the circuitry..

its the motherboard and components getting hot that will cause you a problem..

[.: JaCkPoT :.]

well i did tell u im stupid

[hreich]

well i did tell u im stupid

Thanks to all...will try later today

[tab99_uk]

Thanks to all...will try later today

are you celebrating 1 year anniversary of this thread look at the date .

[hreich]

Well, i didnt use dm 500 for one year now, beacuse of hight temp isnide it, which caused freezing of picture. Now I would like to add fan from pc inside, where should I solder the red wire, and where to solder black one?

are you celebrating 1 year anniversary of this thread look at the date .