TM1500& TM1000 Will not go to standbye

[Manic01]

I just tried 296 and it dl ok.

[Nutsandbolts]

Thanks m 296p corrupt on down load. 2007 patch sorted standye problem but still unable to get into diagnostic mode regards.

Hi. Why dont you try to disable the patch and try to see if diagnostics works. If it works then you know its a patch problem
and if does not work then your best bet is to reload original firmware from TM site. To disable the patch do the following, this works for TM5400 but not sure about your boxes.

MENU - SYSTEM INFORMATION - then enter 2004 on remote. This will disable the patch. To re-enable the patch repeat the process.

Good luck.

[yamaha1]

Hi Manico01 just to clarify what i meant was that i can down load 296 and it opens with header error. regards.

[yamaha1]

296 found elsewhere loaded ok. Stand bye ok but still unable to get into diagnostics. Regards.

[Manic01]

Why do you want diagnostics option?

[yamaha1]

Two fold. 1- have a look around 2- change rf frequency. regards.

[Manic01]

RF freq can be changed from normal menu.

[Nutsandbolts]

Hi. Surely the tv should pick up the RF signal from receiver anyway so long as cable is connected.

Regards.

[dick b]

Hi. Surely the tv should pick up the RF signal from receiver anyway so long as cable is connected.

Regards.

it wont just pick it up you need to go into the TV setup menu and either do an "auto tuning"scan or set the channel number in manual scan to the same as that set in the TMs system setting menu sub menu A/V output setting

[Nutsandbolts]

Hi. Why dont people use scart leads like i do............

Take care.

[digicon]

Hi. Why dont people use scart leads like i do............

Take care.

Probably because some people may want to watch there receiver in another room or another part of the house aka Sky Magic eye style.

[Nutsandbolts]

Probably because some people may want to watch there receiver in another room or another part of the house aka Sky Magic eye style.

You can always use a video sender like i do as well.

Take care

[Manic01]

You are the pioneer of the Technomate world, well done.
Take care now.

[Nutsandbolts]

You are the pioneer of the Technomate world, well done.
Take care now.

Well said Manic. Totally agree with you.

Regards

[Manic01]

Keep us up to date with any new revolutionary ideas you have please.
Take care.