If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Do the two channels being recorded/viewed have to be on same transponder? I asked some where else and they reckoned they did, but I don't understand why if watching off one lnb and recording off another?
hi mate.the answer to your question is no,you should be albe to record two seperate channels without them being on the same transponder.
Ok, I sorted out the problems with mgcamd running on my box.
Had to change B: to { 06 } as pointed out above but also had to change L: to { 00 }
Then within softcam manager I stopped all cams and disabled the auto-start of all cams, then did a reboot. After the reboot went back into softcam manager and then selected mgcamd to auto-start and then did another reboot. After this reboot the box automatically started mgcamd, I then tested a restart of enigma2 and mgcamd also auto started mgcamd.
Found the above on another forum and thought I'd give it a go and it worked for me.
where is softcam manager in BH ? and how do u disable all cams auto start?
Ok, I sorted out the problems with mgcamd running on my box.
Had to change B: to { 06 } as pointed out above but also had to change L: to { 00 }
Then within softcam manager I stopped all cams and disabled the auto-start of all cams, then did a reboot. After the reboot went back into softcam manager and then selected mgcamd to auto-start and then did another reboot. After this reboot the box automatically started mgcamd, I then tested a restart of enigma2 and mgcamd also auto started mgcamd.
Found the above on another forum and thought I'd give it a go and it worked for me.
I know this is an old thread but i just wanted to say thanks it worked perfect.
Comment