eurovox 5000 pvr hard drive doesn't record

[vinnyg]

allways make sure box is unpluged when inserting hard drive, and leave it off for 1 minute and then switch on.

[hackitt]

allways make sure box is unpluged when inserting hard drive, and leave it off for 1 minute and then switch on.

Oh thanks for that!

[jon523115]

JTAG tut I used from other forum modified for EX5000, if you get any errors (apart from those mentioned) power box off and start again.


Connect JTAG and Power up EuroVox

Start JKEYS

Click on "Development Panel"
Click OK to ingore the warning.

** SEE BELOW IF YOU GET AN ERROR HERE **

If all goes well you will get into the development panel.

In the user functions box:

Type in the address: 80000000 (eight and seven zeros)
Click on "Load to . . ."

Select the file "unlock_28FxxxC3.bin"

Click "Trigger User"

Close the current window.

Click on "Flash Programming"

Choose the model number as: DXD426RD (1 Chip-GLA)


In the section on the right:

Leave the box above set to "Full"

(Click "Read" and save file if you want to back up existing TSOP)

Click "Erase"

Select YES. This will take a minute to erase.

Click on "Program"

Select YES to "Program at address 0x7FE00000, size 0x200000?"

Choose your TSOP file- DXD426RD(1Chip-GLA) - Flash 1(28F160) - Full.bin
Sit and wait for OK to become active, then click it.

Close JKEYS and power the box down.

Disconnect your JTAG

Power the box on. If all has gone well then it should boot up ready for you to rescan for your channels.




*** If you get an error trying to get into the devleopment windows ****

Power the box down and run SkyMax v2.2
Select 2Mb Adr Flash
Power the box up
Press start.

This seems to reset the box when JKEYS cannot connect (DCU errors).

Close SkyMax and start JKEYS and try again.