If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Got 3 SV2 boxes, none mine! and 2 work fine following the readme instructions with the fix but 1 of them just says 'data is being updated' on scrambled channels. Sometimes it will go up to 80% then go off other times it stays on 0%. The key emu is on and I did a full scan when I plugged it in.
I have Starview 1 i think had it for a few years now, i currently have on my Starview box the following firmware
Api Ver 4.00e_E
Boot Ver 7.00
Issue Date 2007,
Is their any lates firmware i can down load too flash my box so that i can watch the boxing tomorrow night, been without any channels for over a week now, been resorting too reading books which is never fun....
If any you Starview Gurus could PM me any intructions will be very much appreciated.
just want to say a big thanks to all you guys and girls on this site for helping me get box up and running aswell as xbox 360 luv to you all will use site daily from now on thanks again
Last edited by DAZ nitro; 5 December, 2008, 12:48.
Comment