X-Prog M

[bolonc]

Never buy X-prog-m v5.3 its fake, never buy from Carsung - worst seller from China.
If anyone is interested, this version of the software they provide with X-prog-m v5.3. This software runs on any China's X-prog-m v4.5(after update), v5.0, v5.3. Don't have authorization for Freescale MAC7xxxx (do not even dream)

http://www.digital-kaos.co.uk/forums...ml#post1452213

[Bllinda]

Hello,

I read I2C, microwire and HC908AZ32 ((J66D) 24417 008_temic Combo), out of luck. What you need to check the read and write x-prog-m v.5.0?
Thank you.

Are cloned_Xprog-m can scan and 08.as.32.60_08.az.32.60? When someone is lucky to read?

[dimitar]

Are cloned_Xprog-m can scan and 08.as.32.60_08.az.32.60? When someone is lucky to read?

What do you mean with scan. I have tested all the mentioned versions of motorola and ive never had any problem

[Bllinda]

I'm out on this connection scheme is not very good at scanning.
What am I doing wrong that does not scan.

[dimitar]

I'm out on this connection scheme is not very good at scanning.
What am I doing wrong that does not scan.

This connection is for xprog not xprogm

[kautuvera]

This connection is for xprog not xprogm

It is possible but there is a problem
http://www.digital-kaos.co.uk/forums...0/#post1528162

[dimitar]

It is possible but there is a problem
http://www.digital-kaos.co.uk/forums...0/#post1528162

of course you need the correct security bytes.

[Bllinda]

This connection is for xprog not xprogm

One of these connectors will be good?

[vivian3]

I think the company you mean is autobink.com

[beats2006]

Anyone know if you can buy the eeprom adapter board seprately from anywhere?

[Bllinda]

please can some one show or drawn this plate diagram for 908 mcu
and from where should come the Oscillator connection from the x prog

Maybe someone already using this adapter?

[napel]

Hello mates, my xprog-m was working good for 6 month, now it is seen by program, but when I want to read something, it shows- Initialising Hardware: DEVICE IS SILENT

[gadroulll]

check if you connect the usb cable in software you can seen the port that is connected.

press to read a memory and notice if the green lamp is open . if not you must cahnge the usb cable or port of computer.

if you see the green lamp measure if the 5v is always on in the adaptors if yes you have a burn mosfet 8pin in your hardware. i have repair a lot of times my clone xprog

[motorsport]

hello all any one have test new xprog V5.3 with dongle?

[Min2xx]

hello all any one have test new xprog V5.3 with dongle?

All about Xprog you can find here

And no any new Xprog with dongle or without New Xprog box only!