PS80/PS90 tablet key programming

[sleepyrz]

Hi, ray-ray

Do you have any idea how to programming smart key function with this car?

I programmed immobilizer function with Autopropad .

but there no smart key or remote function option on Autopropad.

manual on board programming for that part

its non diagnostic



Driver's door open, all other doors closed, key removed from ignition
switch.


Within 5 seconds:
Insert and remove the key from the ignition switch twice.
2. Within 40 seconds:
Close and open driver's door twice.
Insert and remove the key from the ignition switch.
3. Within 40 seconds:
Close and open driver's door twice.
Insert the key into the ignition switch and close the driver's door.
4. Switch ignition ON and OFF:
A. Once to program a key remote transmitter code whilst retaining the
original codes.
B. Twice to program a key remote transmitter code whilst erasing the
original codes.
C. Three times to check how many key remote transmitters are currently
registered.
D. Five times to erase all registered codes.
5. Remove key from ignition switch. System should now lock and
unlock vehicle
once, twice or five times depending which mode has been
selected. One to four
times, slowly, to indicate number of key remote transmitters
registered.
6. Within 40 seconds:
Press and hold LOCK and UNLOCK buttons simultaneously for
1.5 seconds.
Within 3 seconds: Press any key remote transmitter button.
System should now lock and unlock vehicle once to confirm
registration or twice
to indicate registration has failed.
7. Within 40 seconds:
To program additional remotes repeat step 60 now on each
additional
remote you want programmed.
8. To exit programming mode open driver's door or insert key into
ignition.
9. Step out of car with remote(s) in hand and test remote(s).