Recover Dead Skybox/Openbox Flash Using Serial RS232 Null modem Cable

[slugworth]

use the correct loader or turn the receiver on slower

[nizamlc]

set stb memory error..
how to fix this

[sonsofdan]

openbox x3 on loop

I have an openbox x3 stuck on load wot I mean is it rolls the L numbers at power on gets to L100 then goes back to the begining ..
I was putting the latest firmwear on box but did a factory reset first,but it finished up going into this load-up loop
I have downloaded all the files for openbox X3 and F3 skybox (eeprom _upgrade..ect )but cannot get my X3 to flash ....has anyone had an X3 with this problem and got it back on its feet .or is there a tut or magic file out there Ive missed
I have spent days trying to flash this box
its one week old
any reply most wellcome

[CMPunk71]

i get the skybox f3 to scan but it crashes after getting to 34% im using USB connected aswell

[slugworth]

As long as it's just a corrupt or blank flash,the receiver can be fixed.I kill my receiver daily with oddball firmware and then revive it.

[FreedomUserGhana]

I am in Ghana and I wish I could pay the guy who put up this tutorial for his service. I have revived a dead clone open box S10 and another open box s10 that the electronics repairer said was not useable and condemned with this software thanks for opening my eyes and the wisdom imparted into me. God bless you

[slugworth]

need db9 female to female

[FreedomUserGhana]

I have a console cable( one DB9 and the other end RJ 45) can I use it to revive my dead open box S10

[FreedomUserGhana]

My open box s10 from China is dead .... I want revive it

[CMPunk71]

mine died after i was scanning new channels, nothing will come on at all at the back near the ethernet adapter the green light is on.. i have the skybox f3

[sayeef]

I'm going to buy an RS232 to USB cable off eBay so I can use it on my laptop and I was wondering if this would work on a S11

USB to Serial DB9 Pin RS232 DB25 Parallel Printer Cable GPS PDA 1M 1.2M 1.5M 2M | eBay

[M4NIK]

what cable is need for rs232 on openbox m3 as i have red light error
thanks

[slugworth]

load anonymousx firmware,you are stuck using that from now on.

[menace465inc]

needhelp

needhelp for my s12 ....after "boot" "--"

[eziorec]

The problem was boot loader corrupted.
Red light only can be boot loader problem.

I wasn't able to refresh it because of com1 wrong configuration.
With new swttings erom upgrade works.

Now after powering I can see scanning on display...