VAG-COM/VCDS EVERYTHING

[batja]

If you have Atmega, then check if you can flash with usb. If that doesn't work, then solder wires / make connections and use usbasp to flash (or other programmer). After that you can flash the language you want with usb connection.

I flashed in English 18.9 without problems and German version was then without a license

[alexm1]

I flashed in English 18.9 without problems and German version was then without a license

You tell us only a half of your story...
Reflash by usbasp or USB?
Reflash only english you have Valid Lincense For English - reflash again with German (test-choose ok for firmware update) - you gonna get Valid License for both languages.

Now, something else I wanna show you:
Temperature test with ATF and GAL HW version- enviroment power up 12v and connected to PC for about 10 min.

[batja]

You tell us only a half of your story...
Reflash by usbasp or USB?
Reflash only english you have Valid Lincense For English - reflash again with German (test-choose ok for firmware update) - you gonna get Valid License for both languages.

Now, something else I wanna show you:
Temperature test with ATF and GAL HW version- enviroment power up 12v and connected to PC for about 10 min.

I had 17.3 software with German firmware 46 and then flashed with usbasp. It works now but only English version with loader 7.1 Software 18.9 and if I German version shows it with the coding that it is not licensed version ... I must now HW Flash 0x46 german and then in the program VCDS make update? for it to work

[DKa0S]

SAM_2794.JPGSAM_2793.JPGHexv2. Using little pins for upgrade?

[kayne30]

can someone help me to make my original hex v2 unlimited

[rak183]

can someone help me to make my original hex v2 unlimited

Write pm to user hid3.

[rak183]

[/QUOTE] I must now HW Flash 0x46 german and then in the program VCDS make update? for it to work[/QUOTE]


Yes.

[kaalis]

Using little pins for upgrade?

What you want to upgrade in this cable - upgrade to atmega162?

[undercoversr]

Hello. I have a problem. When I flash my cable, my laptop battery shutdown. Now atmega no response, diode on cable no blink. I use usbisp

[rak183]

Hello. I have a problem. When I flash my cable, my laptop battery shutdown. Now atmega no response, diode on cable no blink. I use usbisp

Try to reflash ir with USBasp again and report.

[alexm1]

And double check programmer PINOUT and connections To Atmega.

[undercoversr]

I try reflash on usbasp and programmer sp200s - no response. When i connect 12v to odb pins diode on cable does not light.

[batja]

I try reflash on usbasp and programmer sp200s - no response. When i connect 12v to odb pins diode on cable does not light.

you have to flash eprom and flash again and pay attention to settings of usbasp.

[alexm1]

I try reflash on usbasp and programmer sp200s - no response. When i connect 12v to odb pins diode on cable does not light.

Ok, put 12v via obd2 and check voltage, with multimeter, on LM7805- IN (12v) and OUT(5V) Search PINOUT for LM7805. Midlle is common Ground.

[liviudiaconu]

If battery shutdown, 99% must unlock the uC. Paralel programmer or Atmega doctor.