If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I had the same issue your having with a solo, would take the flash stuff but just not do anything, after returning it to the factory it was a mainboard bad flash issue so certainly need to send it back sadly.
it can fry things if not protected,but as yours was protected it was just bad parts/etc that failed.i use full protection on all cable entries to units,sat,lan,power etc.
Comment